Wagan Smart AC Provozní pokyny Strana 2

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 4
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 1
USER’S MANUAL — Please read before using this equipment.
© 2007 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
3
Smart AC 200W with USB
By Wagan Tech
WARNINGS
Keep the inverter away from children.
Do not operate the inverter with wet hands because of an electrical
shock hazard.
This device produces voltage similar to wall outlets at home and
should be treated with the same caution.
OPERATION
The cigarette lighter Adapter (DC plug) is fused at 20 amps. The plug allows the
Inverter to be easily connected to a cigarette lighter socket or accessory socket in a
vehicle. Removing the accessory socket plug allows the inverter to be powered
from an airline power receptacle.
FOR POWER CORD WITH CIGARETTE LIGHTER ADAPTER INSTALLED:
Insert the DC plug into the vehicles accessory socket
Turn the ignition switch to the accessory position, if necessary.
Insert appliance plug(s) into AC socket(s) at the front of the inverter.
Turn on the power switch that is located on the front of the Inverter
The green LED will light to confirm that AC output is present.
After use, turn OFF the inverter and disconnect the plug from the
accessory socket.
NOTE FOR VEHICLE USE
This inverter has features that will prevent your battery from being completely
discharged. An automatic shutdown will initiate when the battery voltage is 10.5
volts. If this occurs we recommend operating your engine for 10-20 minutes to
recharge the vehicle's battery.
www.wagan.com
4
USB POWER PORT
When the inverter is powered, the USB Power Port provides 5 volts DC up to 0.5
Amps for charging cell phones, PDAs and MP3 players. The user supplies the
charging/power adapter cord.
Follow the above instructions to power the inverter.
1. Connect the device to the adapter cord
2. Plug the USB connector into the USB Port
3. Turn on the device
4. After use, turn off the device and turn off the inverter.
5. Disconnect the USB connector from the inverter.
6. Disconnect the inverter from its power source.
CAUTIONS
If you use a battery charger to recharge your battery, be sure to disconnect the
inverter first. Failure to disconnect the Inverter prior to connecting a charger may
result in an input voltage spike that can damage the Inverter.
Powering this inverter with greater than 15 volts DC can damage the inverter and
void the warranty.
Do not use an extension cord between the DC power source and the DC input of
the Inverter. An extension cord on the DC input can create a voltage drop that can
reduce efficiency and output.
Do not open the case of the inverter. There are no user serviceable parts inside.
Do not let the cord of the inverter or any appliance cord get wet. Do not operate
this Inverter in or around water. Water can damage the Inverter. Water damage is
not covered under warranty.
Zobrazit stránku 1
1 2 3 4

Komentáře k této Příručce

Žádné komentáře